Abstract
The manufacture of bent tubes made of high-strength materials requires high bending loads, which lead to large springback and eventually distortion of the cross-section. The incremental tube forming process allows significant reduction of the bending moment. This is achieved by combining the continuous bending process with an incremental tube spinning process. The paper describes an analytical model to predict the bending moment reduction as a function of the superposed spinning process parameters. Experimental results are provided to validate the theoretical results. This model allows the design and optimization of the incremental tube forming process with low springback.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.