Abstract
This paper proposes an analytical model to describe rock drilling processes using drag bits and rotary drills, and to induce relations among rock properties, bit shapes, and drilling parameters (rotary speed, thrust, torque, and stroke). In this model, a drilling process is divided into successive cycles. Each cycle includes two motions: feed and cutting. According to this model, drilling torque includes four components generated from cutting, friction, feed, and idle running respectively, the first three items are all proportional to the uniaxial compressive strength (UCS) when the penetration rate is constant. Laboratory tests verified the correctness and effectiveness of the proposed model qualitatively. Especially, the influence of friction on the flank face and the idle running was confirmed. Field experiments were performed. The results showed good correlation between the torque, penetration rate, and UCS. The proposed model and equations engender the possibility of eliminating useless components of cutting forces when investigating the relation between mechanical data and physical properties of rocks.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
