Functionalized Hybrid Coatings on ABS Surfaces by PLD and Dip Coatings

Abstract

It is important to give water-repellent and antibacterial properties to the acrylonitrile butadiene styrene (ABS) surfaces of the hearing aids. In this study, the sol–gel Si and sol–gel Ti solutions were prepared from the reactions of silicon ethoxide, titanium butoxide and methacrylic acid. The catalyst and Dynasylan F8815 were added to the sol–gel solutions to give hydrophobic properties onto the ABS surfaces. Additionally, silver nanoparticles were synthesized by nanosecond laser and added to the coating solutions to give extra antibacterial properties. The surfaces of the ABS targets were coated using the sol–gel dip coating and pulsed laser deposition techniques. The coatings with good adhesion between film and substrate and good water-repellent properties were achieved. The average contact angles for the coated ABS surfaces were measured in the range between 120 and 125 degrees. The obtained sol–gel materials and produced thin films onto the ABS surfaces were also analyzed in terms of the antibacterial properties. The highly antibacterial properties were observed in the sol–gel solutions and the thin films.