Functionality and Mechanical Performance of Miniaturized Non-Assembly Pin-Joints Fabricated in Ti6Al4V by Laser Powder Bed Fusion.

Abstract

Listen

Translate article

In this work, additively manufactured pin-joint specimens are analyzed for their mechanical performance and functionality. The functionality of a pin-joint is its ability to freely rotate. The specimens were produced using laser powder bed fusion technology with the titanium alloy Ti6Al4V. The pin-joints were manufactured using previously optimized process parameters to successfully print miniaturized joints with an angle to the build plate. The focus of this work lies in the influence of joint clearance, and therefore all specimens were manufactured with a variety of clearance values, from 0 µm up to 150 µm, in 10 µm steps. The functionality and performance were analyzed using torsion testing and tensile testing. Furthermore, a metallographic section was conducted to visually inspect the clearances of the additively manufactured pin-joints with different joint clearance values. The results of the torsion and tensile tests complement each other and emphasize a correlation between the joint clearance and the maximal particle size of the powder utilized for manufacturing and the mechanical behavior and functionality of the pin-joints. Non-assembly multibody pin-joints with good functionality were obtained reliably using a joint clearance of 90 µm or higher. Our findings show how and with which properties miniaturized pin-joints that can be integrated into lattice structures can be successfully manufactured on standard laser powder bed fusion machines. The results also indicate the potential and limitations of further miniaturization.