Fuming nitric acid treatment of polyethylene. IV. Morphology of drawn polyethylene

Abstract

AbstractDrawn PE of different draw ratios (ranging from 1 to 25) and thermal treatment (annealing temperature 80, 100, 110, 120, 127°C.) was treated with fuming nitric acid at 80°C. Weight loss, molecular weight, elastic modulus, and thermograms were measured for annealed and unannealed samples as a function of the treatment time and draw ratio. As a consequence of the preferential oxidation of the noncrystalline portions, there occurs initially a high rate of weight loss and a steep drop in molecular weight, followed by a lower rate of weight loss at nearly constant molecular weight. The elastic modulus stays practically constant up to the moment where the brittleness of the sample prevents further measurement. During the later period the thermograms exhibit one melting peak during the first melting. The remelt of the same sample, however, has two melting peaks with a relative intensity independent of the treatment time. That the two melting peaks are caused by two components of different molecular weights present in the sample is substantiated by fractionation. At very high annealing temperature (127°C.), two peaks appear, not only in the first melting curve of the etched sample, but also in the melting curve of the unetched material. Such an effect is the consequence of partial melting during annealing followed by new crystallization during cooling the sample to room temperature. The findings are related to the morphology of the drawn material under the assumption of preferential scission of chain loops in the amorphous‐crystalline sandwich layer model.