Abstract
Maxillary defects pose challenges for prosthodontists, especially when patients have no remaining teeth. This clinical report describes rehabilitation with a complete denture obturator fabricated in 2 visits for an edentulous patient after a maxillectomy. The obturator base and artificial teeth were digitally designed and merged into a 1-piece prosthesis. Following a virtual reduction, the integrated prosthesis and a gingival veneer were calculated and then printed and bonded together to complete the fabrication. Balanced occlusion was achieved with the assistance of a digital occlusion analyzer at the insertion visit. This approach avoided base-tooth assembly deviations and provided a prosthesis with good patient-reported outcomes at the 6-month follow-up.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
