Abstract
This paper presents a fully digital modulation calibration technique for channel mismatch of TIADC at any frequency. By pre-inputting a test signal in TIADC, the mismatch errors are estimated and stored, and the stored values will be extracted for compensation when the input signal is at special frequency which can be detected by a threshold judgement module, thus solving the problem that the traditional modulation calibration algorithm cannot calibrate the signal at special frequency. Then, by adjusting the operation order among the error estimation coefficient, modulation function and input signal in the calibration loop, further, the order of correlation and modulation in the error estimation module, the complexity of the proposed calibration algorithm is greatly reduced and it will not increase with the number of channels of TIADC. What's more, the hardware consumption of filters in calibration algorithm is greatly reduced by introducing a CSD (Canonical Signed Digit) coding technique based on Horner's rule and sub-expression sharing. Applied to a four-channel 14bit 560MHz TIADC system, with input signal at 75.6MHz, the FPGA verification results show that, after calibration, the spurious-free dynamic range (SFDR) improves from 33.47dB to 99.81dB and signal-to-noise distortion ratio (SNDR) increases from 30.15dB to 81.89dB.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.