Fully Coupled Analysis of Reservoir Compaction and Subsidence

Abstract

ABSTRACT This paper discusses the differences between fully-coupled and uncoupled formulations of models of production and subsidence. For highly compacting hydrocarbon reservoirs, production can cause com-paction of the reservoir and subsidence of the over-burden, and in turn, compaction and subsidence can affect the productivity of the reservoir by increasing the reservoir pressure (i.e., the so-called compaction drive). Intuitively, analyses of production and subsidence should be done in a fully-coupled fashion. However, most, if not all, of the analyses done so far on compacting reservoirs are uncoupled where production and subsidence are calculated in a staggered manner. The results of the numerical analyses using an uncoupled reservoir simulation, and a fully-coupled finite element simulation based on Biot's formulation (both coupled and uncoupled simulations are based on single phase fluid) of a typical compacting reservoir are presented and compared. Different pore pressure response were obtained depending on whether an uncoupled or a fully-coupled analysis was performed, and also depending on whether there is arching of the overburden or not. The results of fully-coupled analyses of compaction and subsidence showed that the generation of additional pore pressure due to compaction cannot be correctly analyzed by simply adjusting the rock compressibilities in reservoir simulation. The most pronounced effect of coupling, obtained from the numerical simulations, is on the possibility of pore pressure increase close to the reservoir flanks even during production. The implications of the differences in the results of fully-coupled and uncoupled simulations are discussed.