Abstract
The nanostructure of the active layer in polymer/fullerene bulk heterojunction solar cells is known to have a strong impact on the device performances. Controlling the polymer/fullerene blend morphology is therefore particularly important. In this work, a rod-coil block copolymer, based on a regioregular poly(3-hexylthiophene) electron-donor rod block and a C60-grafted coil block, is used as compatibilizer and its influences on the thin film morphology as well as the photovoltaic performances are investigated. It is shown that a small fraction of compatibilizer can enhance the device performances in an otherwise non-optimized process. At higher fractions or long annealing times however, the fullerene-grafted copolymer is found to behave as a nucleation center and triggers the formation of fullerene crystals.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have