Abstract

Full-scale application of partial nitritation and anammox in a single suspended-growth sequencing batch (SBR) reactor presented here confirm the process suitable for removing nitrogen from ammonium-rich wastewater with low concentrations of BOD and suspended solids: details of simple and robust process control based on online ammonium or conductivity signals are discussed by describing the full-scale startup at three municipal plants (five reactors in total). Ammonium oxidation rates of up to 500 gN m(-3) d(-1) with conversion to N2 of over 90% are achieved in a full-scale plant, but pilot results indicate that significantly higher rates are feasible. With continuous aeration at dissolved oxygen concentrations <1 mgO2 x L(-1), the nitrite oxidation and the anammox reaction occur simultaneously, allowing increased overall performance and simplified process control compared to separate aerobic end anaerobic phases (segregated either temporally or in different reactors). Sedimentation of the sludge requires special attention only during startup. Although the observed N2O emissions were slightly higher than in conventional nitrogen removal, the overall greenhouse gas emissions were lower, mainly due to energy-saving.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.