Full-length standing radiographs can be used for determination of the Femoral neck-shaft angle but not acetabular coverage.

Abstract

Introduction: The exact evaluation of hip morphology is essential for surgical planning. A wide range of morphometric measures of the acetabulum is deduced from conventional anterior-posterior (ap) pelvic radiographs. Full-length weight-bearing radiographs (FLWBR) also depict the acetabulum and are commonly used for osteotomy planning of the lower limb. This study aimed to determine whether FLWBR can be used to evaluate acetabular morphology. Methods: Radiographs of patients receiving a hip workup that included a conventional ap pelvic X-ray and FLWBR were utilized for radiographic measurements. The following parameters were measured: extrusion index of the femoral head, anterior wall index, posterior wall index, lateral center edge angle (LCE), acetabular index, pubic arc angle (subpubic angle), and centrum-collum-diaphyseal angle (CCD). Results: FLWBR depicted a significantly reduced anterior coverage (p = 0.049) and increased posterior coverage (p < 0.001), higher acetabular index (p = 0.015), and higher pubic-arc angle (p = 0.02) compared to conventional ap pelvic radiographs. There were no significant differences regarding the CCD angle (p = 0.28), extrusion index (p = 0.31), and LCE (p = 0.16). Discussion: The CCD angle of the femur can be measured on conventional ap radiographs and full-length weight-bearing X-rays for lower limb deformity analysis. However, FLWBR will depict an anteverted acetabular morphology, rendering conventional ap radiographs necessary for planning pelvic osteotomies.