FTIR assessment of poly(ethylene oxide) irradiated in solid state, melt and aqeuous solution

Abstract

FTIR spectroscopy was used to study poly(ethylene oxide), PEO, irradiated in solid and molten aggregate states and as aqueous solutions of various concentrations. The changes in shape and width of –C–O–C– complex absorption intensities at around 1112cm−1 were the most prominent. On irradiation of solid samples in contact with air shrinking of –C–O–C– complex and increase in its absorption intensities indicated predominant degradation. Crosslinking prevailed on irradiation of molten PEO and of its aqueous solutions in nitrogen atmosphere and manifested itself as widening of –C–O–C– absorption and decrease of corresponding intensities. Partial or complete merging of CH2 wagging vibrations at 1342cm−1 and 1360cm−1 that are characteristic of crystalline PEO into a single absorption at around 1350cm−1 indicated amorphization what was observed for samples that had reduced degree of crystallinity determined by differential scanning calorimetry. DSC could not discriminate between degradation and crosslinking while the changes in width and shape of –C–O–C– complex were independent of the changes in crystallinity. Comparison of FTIR spectra of the same PEO samples obtained as thin film and as KBr pellets revealed that pellet preparation results in a number of spectral artefacts.