Abstract

BackgroundWhile the static structure of the intracellular Ca2+ release channel, the ryanodine receptor type 1 (RyR1) has been determined using cryo electron microscopy, relatively little is known concerning changes in RyR1 structure that accompany channel gating. Förster resonance energy transfer (FRET) methods can resolve small changes in protein structure although FRET measurements of RyR1 are hampered by an inability to site-specifically label the protein with fluorescent probes.Methodology/Principal FindingsA novel site-specific labeling method is presented that targets a FRET acceptor, Cy3NTA to 10-residue histidine (His) tags engineered into RyR1. Cy3NTA, comprised of the fluorescent dye Cy3, coupled to two Ni2+/nitrilotriacetic acid moieties, was synthesized and functionally tested for binding to His-tagged green fluorescent protein (GFP). GFP fluorescence emission and Cy3NTA absorbance spectra overlapped significantly, indicating that FRET could occur (Förster distance = 6.3 nm). Cy3NTA bound to His10-tagged GFP, quenching its fluorescence by 88%. GFP was then fused to the N-terminus of RyR1 and His10 tags were placed either at the N-terminus of the fused GFP or between GFP and RyR1. Cy3NTA reduced fluorescence of these fusion proteins by 75% and this quenching could be reversed by photobleaching Cy3, thus confirming GFP-RyR1 quenching via FRET. A His10 tag was then placed at amino acid position 1861 and FRET was measured from GFP located at either the N-terminus or at position 618 to Cy3NTA bound to this His tag. While minimal FRET was detected between GFP at position 1 and Cy3NTA at position 1861, 53% energy transfer was detected from GFP at position 618 to Cy3NTA at position 1861, thus indicating that these sites are in close proximity to each other.Conclusions/SignificanceThese findings illustrate the potential of this site-specific labeling system for use in future FRET-based experiments to elucidate novel aspects of RyR1 structure.

Highlights

  • The ryanodine receptor type 1 (RyR1) is an intracellular Ca2+ release channel that plays a central role in skeletal muscle excitation contraction coupling

  • Incubation of His6-tagged green fluorescent protein (GFP) with 4 mM Cy3NTA resulted in a 75% decrease in GFP fluorescence that was completely reversed by 5 mM EDTA (Fig. 2b)

  • Incubation of GFPHis6 with either 4 mM Ni2+ or 4 mM Ni2+/nitrilotriacetic acid/Ni2+ (NTA) did not enhance GFP quenching (Fig. 2b) and no GFP quenching was observed in the presence of Cy3 alone or when Cy3NTA was added in the presence of 150 mM imidazole

Read more

Summary

Introduction

The ryanodine receptor type 1 (RyR1) is an intracellular Ca2+ release channel that plays a central role in skeletal muscle excitation contraction coupling. This enormous homotetrameric protein embedded in the sarcoplasmic reticulum (SR) is part of a macromolecular complex that includes calmodulin, FK506 binding protein 12 kDa (FKBP12), the skeletal muscle voltage gated Ca2+ channel isoform (Cav1.1), and cyclic AMP dependent protein kinase [1]. While the static structure of the intracellular Ca2+ release channel, the ryanodine receptor type 1 (RyR1) has been determined using cryo electron microscopy, relatively little is known concerning changes in RyR1 structure that accompany channel gating. Forster resonance energy transfer (FRET) methods can resolve small changes in protein structure FRET measurements of RyR1 are hampered by an inability to site- label the protein with fluorescent probes

Methods
Results
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call