Frictional Voltammetry with Copper

Abstract

This paper presents an experimental study correlating frictional behavior with in situ voltammetry for a unidirectional sliding contact between a hemispherical tipped alumina probe and a flat rotating copper counterface (maximum Hertzian contact pressure of 68 MPa and sliding speed of 10 mm/s). The contact was immersed in an aqueous 0.1 M Na2CO3 solution (pH ∼11) where the copper counterface acted as the working electrode in a potentiostat controlled three-electrode cell; a coiled Pt wire was used as the counter electrode and a saturated calomel electrode (SCE) as the reference. Clear and reproducible trends were found between friction coefficient and published data suggesting the onset of particular redox reactions, graphically presented in a frictional voltammetry plot. At anodic potentials primarily associated with the formation of copper(I) oxide (Cu2O) (V vs SCE ∼−0.25), the measured friction coefficient was in the range μ ∼0.4–0.5. At cathodic potentials primarily associated with the formation of CuO, Cu(OH)2, and CuCO3 (V vs SCE ∼−0.10), the friction coefficient transitions to the range μ ∼0.7–1.0. At sustained cathodic potentials associated with reduction of the native copper oxide, Cu2O, (V vs SCE ∼−0.65), the friction coefficient is observed to fluctuate between μ ∼0.2 and 0.5, arguably a result of exposure of bare copper due to non-uniform reduction (fractional coverage) of Cu2O.