Frictional Properties of Simulated Fault Gouges Subject to Normal Stress Oscillation and Implications for Induced Seismicity

Abstract

AbstractUnder critical conditions where experimental fault slip exhibits self‐sustained oscillation, effects of normal stress oscillation (NSO) on fault strength and stability remain poorly understood, as do potential effects of NSO on natural and induced seismicity. In this study, we employed double direct‐shear testing to investigate the frictional behavior of a synthetic, slightly velocity‐weakening (SVW) fault gouge (characterized by self‐sustained oscillation under quasi‐static shear loading), when subjected to NSO at different amplitudes (5%–20% of 5 MPa) and frequencies (0.001–1 Hz). During the experiment, fault displacement and gouge layer thickness were measured. Transmitted ultrasonic waves were also employed to probe grain contact states within the gouge layer. Our results show that fault weakening and unstable slip can be triggered at NSO frequencies ranging from 0.03 to 0.1 Hz and amplitudes exceeding 5%. Interestingly, an amplified shear stress drop and weakening effect were observed when the NSO frequency fell in 0.05–0.1 Hz. Analysis of transmitted ultrasonic waves in tests on the SVW gouge revealed fault dilation, accompanied by unstable slip and weakening. By extending an existing microphysical model (the “Chen‐Niemeijer‐Spiers [CNS]” model), to account for elastic effects of NSO on gouge microstructure and grain contact state, the mechanical and wave data obtained in our experiments on the SVW gouge was reproduced, suggesting an approach for modeling fault instability under upper crustal (SVW) conditions where normal stress is perturbed by subsurface operations, such as periodic gas storage stimulation of reservoir formations.