Abstract
The unlubricated friction and wear behavior of toughened zirconias and toughened aluminas against hardened steel was studied using the Falex ring-and-block technique. Three experimental ZrO2-Y2O3 ceramics, two commercial ZrO2-MgO ceramics and two commercial Al2O3-ZrO2 ceramics were investigated. Each ceramic was tested at 500 rev min−1 (92 cm s−1) and 2000 rev min−1 (367 cm s−1) at normal loads in the range 2.3–40.8 kgf. The materials characteristics of the ceramics before test, the features of the tested samples, and the friction and wear data are presented and related. Under mild wear conditions, all the ceramics exhibited low wear, with the ZrO2-Y2O3 samples having the lowest. The wear of the toughened zirconias exhibited a strong sensitivity to sliding speed, while the toughened aluminas did not. Also, the lower toughness ceramics were susceptible to macroscale structural damage (cracking and chipping) even when the overall wear was low. Micro structural examination of a tested friction pair (ring, ceramic block and wear debris) has shown that the wear process is very complex, encompassing many mechanisms which are described. A generalized wear equation relating wear to load, sliding speed and sliding time is proposed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
