Friction Factor Evaluation Using Experimental and Finite Element Methods for Al-4%Cu Preforms

Abstract

In this study, ring compression tests and finite element (FE) simulations have been utilized to evaluate the friction factor, m, under different lubricating conditions for powder metallurgical (P/M) Al-4%Cu preforms. A series of ring compression tests were carried out to obtain friction factor (m) for a number of lubricating conditions, including zinc stearate, graphite, molybdenum disulfide powder, and unlubricated condition. FE simulations were used to analyze materials deformation, densification, and geometric changes, and to derive the friction calibration curves. The friction factor has been determined for various initial relative densities and different lubricating conditions, and a proper lubricant for cold forging of P/M Al-4%Cu preforms is found. Studies show that the use of lubricants has reduced the friction. However, increase in the number of pores in the preforms leads to excessive friction. The FE simulation results demonstrate a shift in the neutral plane distance from the axis of ring specimen, which occurred due to variations in the frictional conditions and initial relative densities. The load requirement for deformation, effective stress, and effective strain induced, and bulging phenomena obtained by FE simulations have a good agreement with the experimental data.