Abstract
Zirconia–Alumina (ZrO2–Al2O3) composite with three layered structure was prepared, and its friction and wear properties under water lubrication were investigated. The results indicate that the layered composite exhibited better tribological properties comparing with ZrO2–Al2O3 mono-layered composite at same tested conditions. Good combination of toughness and strength as well as subsequently excellent friction and wear properties were mainly contributed to the residual stress of the layered composite, which caused by thermal mismatch of sintering between layers through special design of compositions and structure. Friction coefficient and wear rate of the layered composite decreased with increment of load and/or velocity. The change of tribological properties was also relative to wear mechanisms, micro-cutting, and abrasive wear were main mechanisms at lower load and/or lower velocity but fatigue wear caused by plastic deformation became dominant at higher load and/or higher velocity.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
