Abstract
Abstract In this study, fretting wear in riveted lap joints of aluminium alloy plates was investigated. For the fretting test, 6061-T6 aluminium alloy plates, which are widely used in aircraft construction, and blind rivets were used. Experiments were carried out using a computer controlled Instron testing machine. Fretting surface roughness, microhardness was investigated by metallographic techniques and scanning electron microscopy. Tensile load cycles in the riveted lap joint were found to cause damage to all surfaces. Two contact surfaces where friction occurs were investigated. The contact surface of the lower plate with the upper plate, and the contact surface of the lower plate with the rivet head. As load and cycles increased, fretting scars and surface roughness increased. Consequently, it has been determined that fretting damages occur between the contact surface of the plates and between the plate and the rivet contact surface.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.