Abstract
The frequency and intensity noise of an Yb3+-doped single-frequency distributed Bragg reflector (DBR) fiber laser are effectively reduced by a simple, passive optical-feedback loop (POFL), which consists of only two optical couplers. The feedback loop, which has resonance with the high reflective grating of the DBR laser and relative long optical path compared to the DBR cavity, results in narrower linewidth and lower relative intensity noise (RIN) in the feedback signal. The RIN of relaxation oscillation is reduced by 20dB from -99.9dB/Hz @ 993 kHz to -119.4dB/Hz @ 192 kHz, and the frequency noise was suppressed at frequencies higher than 1 kHz, with a maximum reduction of about 30 dB from 10 kHz to 100 kHz, which results in a spectral linewidth compression from 3.96 kHz to 540 Hz. Even after one fiber amplification stage, the noise did not increase significantly, and a spectral linewidth well below 1 kHz were also achieved at output power of 10W.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
