Framework Fracture of Zirconia Supported Full Arch Implant Rehabilitation: A Retrospective Evaluation of Cantilever Length and Distal Cross-Sectional Connection Area in 140 Patients Over an Up-To-7 Year Follow-Up Period.

Abstract

To evaluate the relationship between different dimensional parameters in implant-supported monolithic zirconia fixed complete dental prostheses (IFCDPs) and the incidence of framework fracture in a large sample of cases in vivo. This retrospective observational study evaluated all patients rehabilitated with screw-retained zirconia IFCDPs between January 2013 and April 2019 at a private practice. The minimum follow-up period was 1 year after occlusal loading. Fractures were classified as: type I-fractures that happened between but not involving the two most posterior screw-access openings (SAOs) and type II-fractures of the distal cantilever. Cantilever length, distal connector cross-sectional area, and screw access opening length were measured using data obtained from digital scans. Logistic regression was performed to evaluate the relationship between types I and II fractures and the independent variables (dimensional parameters). Using the receiver operating characteristic curves, two parameters were identified to be useful for establishing a cut-off and predicting type II fractures. A total of 180 prostheses delivered to 140 patients were analyzed. Five implants failed in three patients: three before delivery of the definitive prostheses and two after. Ten prostheses failed (5.6% prosthetic failure rate): 2 because of implant failures, and 8 because of framework fractures. Five fractures were classified as type I and three as type II. Significant associations were found between cantilever length and type I fractures (Wald = 5.772, df = 1, p = 0.016), distal connector cross-sectional area and type II fractures (Wald = 3.806, df = 1, p = 0.051), and cantilever length and the total number of fractures (Wald = 6.117, df = 1, p = 0.013). Zirconia IFCDPs may be reliable medium-term solutions if some dimensional parameters are followed. The ratios between the cantilever length and cross-sectional connector area should be <0.51, while the ratio between the cantilever length and screw access opening length should be <1.48.