Fracture toughness to assess the effect of trimming on the fatigue behaviour of high-strength steels for chassis parts

Abstract

High-strength steels are widely used in vehicle body-in-white, offering a good balance between crashworthiness and lightweight design. The increased requirements of heavier electric vehicles, in terms of fatigue resistance and crashworthiness, highlight that chassis parts have remarkable lightweighting potential. However, applying these grades in chassis parts is not straightforward, as the forming processes, like trimming, may introduce surface defects that compromise the fatigue resistance of the component. This work presents a material selection strategy for the applicability of high-strength steels in chassis parts of electric vehicles. The proposed approach allows the evaluation of the key parameters of the chassis parts in a simple way. The crash performance is evaluated through fracture toughness using the essential work of fracture (EWF) methodology. The method is applied to thin high-strength steel sheets employing double-edge notched tensile specimens (DENT). On the other hand, fatigue performance is investigated in terms of fatigue resistance for both notched and unnotched specimens. The results for different complex-phase and dual-phase steels show a good agreement between the EWF and the fatigue notch factor. The method could help apply high-strength steel to chassis parts, as designers will have a tool to focus the expensive fatigue tests on the best material candidates.