Abstract
A new method for fracture toughness determination of ceramic balls is presented. The starter crack is introduced into the surface of the ball by a Knoop indentation followed by grinding off the deformed zone. The loading through surface tensile stresses is realized by water quenching, i.e. dropping the heated ball into water. The temperature difference is stepwise increased to find the critical temperature difference for the initiation of crack growth. The geometric factor is calculated in a parametric finite element study, whereas the temperature distribution in the ball was previously determined by using the Biot concept. Combining experimentally measured critical temperature differences for different cracksizes and ball diameters with numerical results of the geometric factor, the fracture toughness of the silicon nitride balls is evaluated. For the evaluation, the knowledge of several material properties (e.g. the CTE) and other parameters is necessary, which have influence on the precision of the measurement. The overall measurement uncertainty is estimated to be about ±10 %, what roughly corresponds to the value determined with standard measurement procedures. There is an excellent agreement with published fracture toughness results of these balls determined by the modified Surface Crack in Flexure procedure.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
