Abstract
Fracture toughness of six dental porcelains with leucite content ranging from 0 to 22 vol% was evaluated by indentation fracture (IF), surface crack in flexure (SCF), and single edge pre‐cracked beam (SEPB) methods. The results of the IF method were similar to those of the SCF method for all the porcelains investigated. The results of the SEPB were similar to those of the other two methods only for the glassy porcelains, but for leucite‐based porcelains this method resulted in higher values of KIc. Based on microstructure, fractographic analysis, and an additional single edge V‐notched beam test, it was concluded that the pre‐crack size influences the value of KIc for porcelains reinforced by leucite. For design and failure analysis purposes, the KIc determined by SCF method should be preferred, since fracture of dental restorations usually starts from small surface cracks.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
