Abstract
In situ composites based on the Nb-Cr-Ti ternary system were processed by rapid solidification in order to reduce the size of the reinforcing intermetallic phase. Two-phase microstructures with small Cr2Nb particles in a Nb(Cr, Ti) solid solution alloy matrix were produced for several compositions that previous work showed to produce high toughness composites in cast materials. The fracture and fatigue behaviors of these composites were characterized at ambient temperature. The results indicate that the fracture resistance increases with a decreasing volume of Cr2Nb particles. Fracture toughnesses of the rapidly solidified materials with their smaller particle sizes were lower than for conventionally processed composites with larger particles of the intermetallic compound. The fatigue crack growth rate curves exhibit steep slopes and a low critical stress intensity factor at fracture. The lack of fracture and fatigue resistance is attributed to the contiguity of the intermetallic particles and the absence of plastic flow in the Nb solid solution matrix. The matrix alloy appears to be embrittled by (1) the rapid solidification processing that prevented plastic relaxation of residual stresses, (2) a high oxygen content, and (3) the constraint caused by the hard Cr2Nb particles.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
