Abstract
The exposure of the implant collar in the esthetic zone is a challenging complication of implant dentistry. The preparation of the exposed implant collar to create room for restorative material may decrease the strength of the abutment/implant assembly. The purpose of this in vitro study was to evaluate the effect on the failure load of preparing a 0.5-mm chamfer finish line on an implant collar at various apical depths. Thirty solid abutments and 30 implants were screwed into a customized metal mold at a 30-degree angle to the vertical axis. An intact group (IN) (control) (n=10) had no preparation, experimental group P1 had a 0.5-mm chamfer margin placed 1 mm apical to the implant/abutment interface, and experimental group P2 had the margin placed 2 mm apical. The specimens were subjected to a fatigue loading of 200 N for 1 000 000 cycles. Unfractured specimens were then loaded until failure. Mean fracture load (MFL) values were compared with 1-way ANOVA, and the Tukey test was used to identify differences among groups (α=.05). One specimen from both the IN and P1 groups and 2 specimens from the P2 group failed after fatigue loading. Significant differences in the MFL values were found between the IN group (3825) and P1 group (2944), P<.001 and between the IN group and the P2 group (2553), P<.001. The mean load required to fracture the abutment/implant assembly decreased significantly after various amounts of implant collar preparation.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
