Fracture prediction of tight sandstone reservoirs using outcrops and log curve-based extremum method: A case study of the Chang 7 Member of the Yanchang Formation in Block X, Ordos Basin

Abstract

The lack of seismic data and special log data on the Chang 7 Member of the Yanchang Formation in Block X of the Ordos Basin poses a major challenge to the study of the development characteristics and identification of fractures that greatly influence on-site production. To overcome this obstacle, this study determined the macroscopic characteristics of fractures in the study area based on field outcrop profiles and indoor core observations. The results are as follows: (1) Fractures in the study area are dominated by regional fractures in weakly deformed structural areas, with three sets of fractures mainly occurring. Core observations show that fractures in the study area have high dip angles, small extensions, and small openings; (2) The vertical extended lengths of these fractures are significantly controlled by rock mechanical layers; (3) Fractures show three types of extended morphologies when meeting weak planes. Vertically, there is an exponential correlation between the sand body thickness and the fracture linear density. The argillaceous shale thickness has a logarithmic relationship to the fracture linear density when it is < 1 m and has an exponential relationship to the latter otherwise. The planar distribution of fractures is significantly affected by layer thickness and rock mechanical properties. Given the stable occurrence, high dip angles, and small extensions of regional fractures, this study highlighted the abnormal increase or decrease in log curve values of fracture segments by calculating the extrema of log curves. The purpose is to identify the locations and quantity of fractures using conventional log curves in the case of limited drilling data. This log curve-based extremum method enjoys a high resolution. For both coring and non-coring wells in the study area, there is a positive correlation between their fracture linear density determined based on the production segment thickness of vertical wells and their daily liquid yield in the first week of well test and pilot production. This result indicates that the method for identifying natural fractures proposed in this study is highly reliable. Moreover, this study provides key parameter controls for predicting the three-dimensional distribution of fractures. The understanding of the fracture spatial distribution is also a key external factor that affects the design and construction of horizontal well fracturing.