Abstract
Abstract— The fracture behaviour of borosilicate glass reinforced by molybdenum and/or vanadium particles has been investigated. For the addition of 5 vol% molybdenum particles, two processing procedures have been tested and the influence of volume fraction of vanadium particles (in the range 2 to 30 vol%) on fracture resistance has been assessed. The use of chevron‐notched specimens in three‐point bending has been shown to be a reliable method for the evaluation of fracture toughness even at toughness levels of order 0.7 to 1.3 MPa √m. The existence of subtle differences in fracture behaviour of glass‐composites having comparable volume fractions of molybdenum particles but obtained by two different processing procedures has been established by statistical treatment of the fracture toughness data. An increase in the volume fraction of metallic particles results in an increase of the fracture resistance and the measured fracture toughness level. Toughening mechanisms which have been identified include both the plastic deformation of particles and the bridging of cracks by ductile particles. Some particle cleavage and debonding has been observed, which indicates that a decrease in particle plasticity, probably induced by processing or due to constraints imposed by the rigid matrix, is responsible for a smaller than expected enhancement of the fracture toughness.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Fatigue & Fracture of Engineering Materials & Structures
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
