Abstract
Using a field-programmable gate array (FPGA) development board, a digital signal processor (DSP) builder, and the phase-to-amplitude conversion principle, a low-cost system for measuring the amplitude-to-amplitude (AM/AM) and amplitude-to-phase (AM/PM) distortion curves of radio frequency (RF) power amplifiers (PAs) is presented. The state of the art based on the measurements and preliminary studies of AM/AM and AM/PM distortion curves is discussed. A full digital control of the test bed simulated/emulated in Matlab/Simulink is introduced to recalculate the known AM/AM and AM/PM measurements stored as look-up table (LUT). Finally, the low-cost system comprises the memory polynomial model (MPM) that involves the nonlinearity order and memory effects of real PAs.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
