Fouling control in a submerged membrane‐bioreactor by the membrane surface modification

Abstract

AbstractTo improve the antifouling characteristics, polypropylene microporous membranes (PPHFMMs) were surface‐modified by the sequential photoinduced graft polymerization of acrylic acid and acrylamide. The grafting density and the grafting chain length, which played important roles in the antifouling characteristics, were controlled in the first and the second step, respectively. The ATR/FTIR results clearly indicated the successful modification on the membrane surface. The static water contact angle of the modified membrane reduced obviously with the increase of the grafting chain length. The contact angle of the acrylic acid modified membranes was lower than that of the acrylamide modified membrane with similar grafting chain length. The grafting chain length increased with the increase of UV irradiation time and monomer concentration. The grafting chain length of poly(acrylic acid) (PAAc) was lower than that of the polyacrylamide (PAAm) under the same polymerization conditions. Pure water flux for the modified membranes increased with the increase of grafting chain length, and had maximums. The antifouling characteristics of the modified membranes in a submerged membrane‐bioreactor (SMBR) were evaluated. The modified membranes showed better filtration performances in the SMBR than the unmodified membrane, and the acrylic acid grafted membrane presented better antifouling characteristics than acrylamide modified membranes. The results demonstrated that the surface carboxyl‐containing membranes were better than the surface amido‐containing membranes. The results of Pearson correlations demonstrated that the PAAc modified membranes with longer grafting chain length had higher flux recoveries, while the PAAm modified membranes with longer grafting chain length had lower flux recoveries. © 2009 Wiley Periodicals, Inc. J Appl Polym Sci, 2010