Forward displacement analysis and uncertainty configurations of parallel manipulators with a redundant branch

Abstract

The effect of adding a redundant branch in terms of reduction of the number of assembly modes and elimination of potential uncertainty configuration types is investigated for a class of parallel manipulators. Considered is a broad class that includes all three-branch manipulators where each branch is comprised of a serial arrangement of three main-arm joints supporting a common payload platform through a passive spherical branch end joint-group. The addition of a redundant branch effectively yields a four-branch manipulator class. Considered in particular is a 3-4 form of the manipulator where two branch ends meet at one point on the mobile platform. Symmetric main-arm joint sensing and actuation (two sensed/acutated main-arm joints per branch) is utilized. Synthetic geometry is used to study the number of assembly configurations of the resulting 3-4 four-branch parallel manipulators. It is presented that the number of assembly modes of three-branch parallel manipulators with passive spherical branch end joints can be reduced by utilizing a redundant branch. It is shown that there exist up to eight and up to four assembly modes when all unsensed joints are revolute and when all unsensed joints are prismatic, respectively. Combinations of unsensed prismatic and revolute joints are also investigated. It is determined that there are up to eight and up to four assembly modes when the unsensed main-arm joint of one of the concurrent branches is prismatic and when the unsensed joints of both concurrent branches are prismatic joints, respectively. Resolving the potential assembly modes require only the consideration of, at highest, second-order single-variable polynomials. In addition, kinematic design considerations allowing reduction of feasible assembly modes are discussed. The investigation of potential uncertainty configuration types is based on examining degeneracies of the screw systems formed by wrenches associated with the forces that the actuated-joints can apply. All linear dependency cases that could potentially cause uncertainties for the class of four-branch manipulators are identified. It is shown that while significantly reducing potential uncertainty configuration types, the addition of a redundant branch number cannot eliminate all potential dependency (uncertainty) cases completely. For the remaining potential uncertainty configuration types, the characteristics of the corresponding unconstrained instantaneous degrees of freedom are discussed.