Formulation design of double-layer in the outer shell of dry-coated tablet to modulate lag time and time-controlled dissolution function: Studies on micronized ethylcellulose for dosage form design (VII)

Abstract

The dry-coated tablet with optimal lag time was designed to simulate the dosing time of drug administration according to the physiological needs. Different compositions of ethylcellulose (EC) powder with a coarse particle (167.5 microm) and several fine particles (< 6 microm), respectively, were mixed to formulate the whole layer of the outer shell of dry-coated tablets. The formulations containing different weight ratios of coarse/fine particles of EC powders or 167.5 microm EC powder/excipient in the upper layer of the outer shell to influence the release behavior of sodium diclofenac from dry-coated tablet were also explored. The results indicate that sodium diclofenac released from all the dry-coated tablets exhibited an initial lag period, followed by a stage of rapid drug release. When the mixture of the coarse/fine particles of EC powders was incorporated into the whole layer, the lag time was almost the same. The outer shell broke into 2 halves to make a rapid drug release after the lag time, which belonged to the time-controlled disruption of release mechanism. When the lower layer in the outer shell was composed of 167.5 microm EC powder and the upper layer was formulated by mixing different weight ratios of 167.5 microm and 6 microm of EC powders, the drug release also exhibited a time-controlled disruption behavior. Its lag time might be freely modulated, depending on the amount of 6 microm EC powder added. Once different excipients were respectively incorporated into the upper layer of the outer shell, different release mechanisms were observed as follows: time-controlled explosion for Explotab, disruption for Avicel and spray-dried lactose, erosion for dibasic calcium phosphate anhydrate, and sigmoidal profile for hydroxypropyl methylcellulose.