Formulation and characterization of 3D printed chickpea protein isolate-mixed cereal dysphagia diet

Abstract

The feasibility study of making 3D printed dysphagia diet was undertaken. A mixture of corn flour and buckwheat flour was used as the model cereal and chickpea protein isolate (CPI) was used as the model protein. Printing gels (inks) of the mixed cereal (control) and CPI-cereal mixture were produced by heating the formulations at 95 °C for 30 min and then cooling them to room temperature. The results showed that all the ink formulations containing CPI had higher apparent viscosity, preferable shear thinning behavior and shape supporting characteristics than that of the control. The cohesiveness and shape supporting ability of 10%CPI-cereal and 20%CPI-cereal formulations were poor and could not produce stable printing shape. The 30%CPI-cereal and 40%CPI-cereal formulations had suitable apparent viscosity, shear thinning behavior, storage modulus, yield stress and printing accuracy and the 3D printed products were stable. The control ink and 10%CPI-cereal ink had low cohesion and also could not pass the spoon tilt test. The 50%CPI-cereal formulation had high hardness and also could not pass the fork pressing test. The 30 % to 40 % CPI-cereal formulations were found to be suitable as dysphagia products as they could be classified as level 5 dysphagia diet.