Formulation & Evaluation of Effervescent Tablet of Verapamil Hydrochloride

Abstract

The chief aim of the present investigation is to study the Formulation & Evaluation of Effervescent Tablet of Verapamil Hydrochloride. The floating tablets of verapamil hydrochloride were prepared by direct compression technique. For each tablet formulation, drug, HPMC-K15M, karaya gum, sodium bicarbonate, and diluents were blended homogeneously for 10 min followed by addition of magnesium stearate. The total weight of each tablet was 300 mg. The amount of karaya gum used was in the range of 40–90 mg, whereas HPMC was used in the range of 20-40 mg. The powder mixture was further mixed for 5 min in a mortar. The resultant mixture was compressed into tablets using a Rimek rotary tablet machine. After preparation, the formulations were evaluated by various parameters. The friability of the tablet formulation varied between 0.3 ± 0.0063 to 0.59 ± 0.0076%. The weight variation of prepared tablet formulation complies with USP limits. The thickness was found to be in the range of 4.1 ± 0.48 to 4.2 ± 0.76 mm. The assay for drug content varied between 96.53 ± 0.36 to 102.03 ± 0.52%. The B1, B5, B6, B9, and B10 exhibited more than 75% drug release at 12 h. The B1 exhibited a maximum of 30 % drug release in the 1st hour and constant release for almost up to 12 h. B8 showed the least drug release among all other formulations; this may be due to the formation of a thick gel barrier on the tablet. Tablets were prepared by direct compression. Technological characteristics of floating tablets were within the Pharmacopoeial limit. Tablets floated for more than 8 h. Complete swelling was achieved by the end of 8 h, so percent swelling was determined at the end of 8 h for all the developed formulations.