Abstract

The necking behavior of sheet metals under stretch-bending process is a challenge for the forming limit prediction. State-of-the-art forming limit curves (FLCs) allow the prediction under the in-plane stretching but fall short in the case under out-of-plane loading condition. To account for the bending and straightening deformation when sheet metal enters a die cavity or slide along a radius, anisotropic hardening model is essential to reflect the nonproportional loading effect on stress evolution. This paper aims to revisit the M-K analysis under the stretch-bending condition and extend it to accommodate both distortionless and distortional anisotropic hardening behavior. Furthermore, hardening models are calibrated based on the same material response. Then the detailed comparison is proposed for providing better insight into the numerical prediction and necking behavior. Finally, the evolution of the yield surface and stress transition states is examined. It is found that the forming limit prediction under stretch-bending condition through the M-K analysis strongly depends on the employed anisotropic hardening model.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call