Forming Limit Diagram Prediction of Tailor-Welded Blank Using Experimental and Numerical Methods

Abstract

The forming limit diagram (FLD) is a useful method for characterizing the formability of sheet metals. In this article, different numerical models were used to investigate the FLD of tailor-welded blank (TWB). TWBs were CO2 laser-welded samples of interstitial-free (IF) steel sheets with difference in thickness. The results of the numerical models were compared with the experimental FLD as well as with the empirical model proposed by the North American Deep Drawing Research Group. The emphasis of this investigation is to determine the performance of these different approaches in predicting the FLD. These numerical models for FLD are: second derivative of thinning (SDT), effective strain rate (ESR), major strain rate (MSR), thickness strain rate (TSR), and thickness gradient (TG). Results of this research show necking will be happened, when the value of MSR, TSR, ESR criteria is maximum, TG ≤ 0.78 and SDT criterion has the first peak in forming process time. The value of dome height of TWB samples at failure was predicted based on the numerical models for samples with different widths. These numerical predictions were compared with the experimental results. The SDT model indicates a better agreement with experimental results in prediction of both the FLD and the limit dome height (LDH) in comparison to the other numerical models. Both numerical and experimental results show that minimum of LDH is happened in plane strain condition.