Abstract
The effect for polymerizable layer on a vertical-type photo-alignment layer was investigated from the point of image sticking characteristics. Fabrication process of the polymerizable layer is followings; photo-alignment treatment is firstly carried out by exposing polarized ultraviolet (UV) from the oblique direction. After construction of the liquid crystal (LC) cell, the LC material including monomers is injected, and unpolarized UV is exposed for formation of the polymerizable layer. For avoiding pretilt angle shift during the exposure, fast rate constant of polymerization is necessary, and mixed monomers 4,4’-dimethacryloyl-oxy-biphenyl (4,4’-DMABiph) and 4,4’-dimethacryloyl-oxy-benzilketal (4,4’-DMABzk) are appropriate for obtaining small level of image sticking parameters. As the image sticking parameters, residual direct current voltage (V rDC) and difference in pretilt angle (Δtilt) before and after application of alternate current voltage were evaluated, and the results of V rDC and Δtilt indicated that 6% 4,4’-DMABzk in the mixed monomers 4,4’-DMABiph and 4,4’-DMABzk would be useful for obtaining the small level of image sticking.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
