Abstract
The aim of the present work is to investigate the microstructure of Al-Pb monotectic surface layers generated by a laser surface alloying technique on the surface of an Al-4Cu-1.5Si-0.5Mg alloy. Monotectic alloys are generally used as materials for sliding bearings. Layers of a monotectic alloy generated by laser surface alloying have a potential for superior properties, because the rapid solidification during this process results in fine precipitation structures which can act as solid lubricant. The structure of the Al-Pb monotectic surface layers was observed in the light microscope and the scanning electron microscope. Volume fraction and size distribution of lead particles were determined by quantitative image analysis. Pin-on-disc experiments were carried out to characterize and compare the tribological properties of the Al-Pb monotecitc layers and cast Al-Cu-Si-Mg alloys.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
