Formation of combustion wave in lean propane-air mixture with a non-uniform chemical reactivity initiated by nanosecond streamer discharges in the HCCI engine

Abstract

The propagation of combustion wave, which is formed as a result of impact of a filamentary pulsed periodic non-equilibrium discharge on a mixture that is not ignited by only compression in the HCCI engine, has been simulated. The discharge for a short time locally activated the mixture in the engine cylinder at a certain crankshaft rotation angle at the compression stage. The approach to evaluation of the temperature and composition in the region activated by high-frequency corona discharge has been proposed. Multi-pulse and multi-channel nature of discharge was accounted for in our model. The densities of chemically active species produced during streamer propagation were found using two-dimensional axially symmetric fluid model. The obtained composition and temperature in the activated zone were the initial conditions for modeling the propagation of combustion wave along the cylinder radius in 1D approximation. Special terms were included in equations responsible for the compression along the axis of cylinder to mimic the real change in pressure in cylinder. The calculations were performed for a lean C3H8-air mixture, which is characterized by the presence of low-temperature heat release (LTHR) stage, and intermediate and high temperatures heat release (ITHR and HTHR) stages. It was shown that the ignition timing in activated zone depends on the specific energy input into the streamer channel, the radius of activated region coupled with the volume fraction of activated region treated by discharge, and the moment of discharge initiation relative to the top dead center (TDC). The speed of combustion wave, the occurrence of auto-ignition in the end gas and transition to combustion, accompanied by “knocking” or strong pressure fluctuations are largely determined by the moment of discharge initiation and the specific energy input. The significant effect of discharge is explained by the stimulation of oxidation kinetic mechanisms at LTHR and ITHR stages.