Formation of CaZrO 3 at the interface between CaO–SiO 2–MgO–CaF 2(–ZrO 2) slags and magnesia refractories: Computational and experimental study

Abstract

The formation behaviour of calcium zirconate (CaZrO 3) at the interface between the CaO–SiO 2–MgO–CaF 2(–ZrO 2) slags ( B (=(mass% CaO) /(mass% SiO 2)) = 2.0) used in the AOD converter and the MgO refractories has been computed by employing a commercial thermodynamic software. The solubility of zirconia (ZrO 2) in the liquid CaO–SiO 2-7 mass% MgO slag phase is relatively small, viz. about 2–3 mass% and the CaZrO 3 phase is formed at about B > 1.5 . The region of fully liquid phase extends to the composition saturated by dicalcium silicate (Ca 2SiO 4) and cubic ZrO 2 ( B ∼ 1.2 ). The effect of 7 mass% CaF 2 addition on the solubility of ZrO 2 in the liquid slag phase was computed to be negligible, while the liquid phase exists through the entire compositions. In addition, the region of fully liquid phase extends to the more basic composition range ( B ∼ 1.5 ), where the saturating phases are the Ca 2SiO 4 and CaZrO 3. The thermodynamic calculations indicate CaZrO 3 not to form at (mass% ZrO 2) /(mass% MgO) ((=Z/M))<0.6. In the “ Liquid+Ca 2SiO 4+MgO” region, the activity of SiO 2 in the liquid phase is nearly fixed because the activity of CaO in the liquid phase is unaffected by the activity of ZrO 2. However, with higher ZrO 2 activity from the increase in the Z/M ratio, the activity of CaO in the liquid phase is expected to decrease due to the formation of CaZrO 3. The formation behaviour of CaZrO 3 in the slags, computed based on the Gibbs energy minimization principles, could experimentally be confirmed by employing the XRD and SEM–EDS analysis.