Formation of banded and non-banded poly(l-lactic acid) spherulites during crystallization of films of poly(l-lactic acid)/poly(ethylene oxide) blends

Abstract

In this study, a series of poly(l-lactic acid) (PLLA)/poly(ethylene oxide) (PEO) blends with different PLLA concentrations was prepared. Films of these blends crystallized with and without a coverslip were characterized by the presence and absence of banded structures, respectively. This difference in morphology was observed because the PEO component of the blends was oxidized at a high temperature (125 °C) in air without the protection of a coverslip. X-ray photoelectron spectroscopy (XPS) results showed that the surface of the blends crystallized in nitrogen without a coverslip contained mostly PLLA while the surfaces of the same blends crystallized under a coverslip contained only a moderately higher concentration of PLLA than their bulks. The migration of PLLA to the surface of the blends during crystallization in nitrogen when no coverslip was used was due to its low surface tension. Phase images obtained using atomic force microscopy (AFM) indicated that the banded structures consisted of valleys and ridges, which were in fact flat-on and edge-on lamellae, respectively. A detailed time-of-flight secondary ion mass spectrometry (ToF-SIMS) examination suggested that PLLA and PEO were located mainly on the surfaces of the ridges and valleys, respectively.