Abstract
The formation of aurum–aluminum (Au–Al) alloy on silicon substrate and its use to be electrode of polymer electro-optic (EO) modulator were investigated. The surface morphology and crystallinity were studied by atomic force microscopy, scanning electron microscope, X-ray diffractometer (XRD) and energy dispersive spectrometer. The electrical resistivity was characterized by the four-probe method. XRD pattern confirmed the formation of AuAl phase. After annealed for 11min at 575°C, the Au–Al alloy film exhibited a root mean square roughness of less than 40nm and a minimum electrical resistivity of 2.24μΩcm with no obvious change within 6 months. The scattering-parameter (S21) of a fabricated co-planar waveguide electrode polymer EO modulator was measured by vector network analyzer, and a 3-dB bandwidth of 5.2GHz was observed. These physical properties promise good potentials of Au–Al alloy to be electrode of polymer EO modulators.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.