Abstract
The two-phase titanium alloy Ti6Al4V (often referred to as GRADE 5 or Ti64) is currently probably the most widely used type of Ti alloy. It is characterized by an excellent combination of strength - toughness - chemical stability. However, at temperatures above 500 - 800 °C it is prone to the diffusion of oxygen into surface layers, where the increased oxygen content creates the so-called “alpha-case” layer. The formation of this layer is associated with a reduction mainly in the deformation characteristics of the alloy. The paper focuses on the metallographic analysis of the "alpha-case" layer after annealing at 1050 °C with a holding time of 3 hours and cooling at different cooling rates (500 °C/s, 1 °C/s and 0.08 °C/s). Microstructure changes were observed by light microscopy using polarized light – PL, dark field – DF and phases were identified by SEM methods. The influence of changes in the microstructure on the mechanical properties was determined by measuring the microhardness HV0.2 /10 (STN EN ISO 6507) with Zwick / Roell ZHµ and measuring the resistance to impact stress KU (Charpy system STN EN 10045-1). Based on the microhardness measurement, an increase in the microhardness of the surface layers was observed at all cooling rates and at the same time, a decrease in the impact resistance was observed compared to the initial state.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
