Formation Damage by Fines Breakage and Migration

Abstract

AbstractFines migration is one of the most drastic causes for formation damage - the detached clays migrate and impairs well productivity. Two types of damaging clays are encountered in petroleum reservoirs: authigenic clays that grew on the grain surfaces during geological times, and detrital clays that have been broken off the grains by local stresses. Detailed laboratory and mathematical modelling have been carried out for detrital-clay formation damage. The theory for formation damage by authigenic clays is not available. The aim of this work is the development of a laboratory procedure to estimate formation damage by authigenic clays and the derivation of a mathematical model for core scale. We performed two test of corefloods using Castlegate core samples. In the first test, injection rate increased in a stepwise manner up to 100 mL/min and in the second one up to a 200mL/min to make sure both detrital and authigenic particles are detached. The pressure drop across the overall core and the concentration of the fine in the produced fluid have been measured. We have derived equations for authigenic-fines detachment using the beam theory and the von Mises failure criteria to obtain analytical solutions for linear system of equations. Matching the laboratory data by the analytical model allows determining the percentage of authigenic and detrital clays in the cores. The laboratory data exhibit a good match with the mathematical model for the two coreflood tests. The non-monotonic change of the concentration of the detached fine, with the initial and final risings, determines the type curve that evidence the mobilization of both, authigenic and detrital clays. The treatment of the measured data in test#2 shows that 82% of the initial attached particles are authigenic. The model parameters in order of decrease of their sensitivity are contact-bond radius, pore radius, particle size, lever-arm ratio, tensile strength and aspect ratio. A novel experimental procedure to determine fines-migration formation damage by authigenic and detrital clays was developed. A newly derived mathematical model allows determining the model coefficients from the laboratory tests and predict future detachment rate of authigenic and detrital particles.