Abstract
The formation and structure of Langmuir monolayers and Langmuir-Blodgett films were studied using water-soluble polymers, which have difficulty forming monolayers on the water surface, and polymers that are insoluble in all solvents. The network copolymers consisting of hyperbranched units with an s-benzenetricarbamide core used in this study can be freely controlled by azidation/non-azidation of both ends of the hard segment. The water-soluble copolymer, which exhibits the properties of a thermoplastic resin, can form a monolayer when spread on the water surface at a low temperature at which the solubility decreases. Even when the subphase temperature increased, no significant change in the monolayer behavior of the thermoplastic copolymer was observed. This behavior was attributed to the formation of an insoluble single-particle layer with hydrophilic groups facing inward on the water surface. The insoluble copolymer, which exhibits thermosetting properties, forms a tablet that floats on the water surface for an extended period. The surface pressure-time isotherms showed the formation of a monolayer from the tablet over time, and it was possible to measure the surface pressure-area isotherms by two-dimensional compression after a certain period of time.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Colloids and Surfaces A: Physicochemical and Engineering Aspects
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
