Abstract
Self-assembled monolayers (SAMs) enable an electronic interface tailoring of conductive metal oxides and offer an alternative to common transparent electrodes in optoelectronic devices. Here, the influence of surface orientation and pretreatment on the formation and stability of SAMs has been studied for the case of phenylphosphonic acid (PPA) on ZnO single crystals. Using thermal desorption spectroscopy (TDS), X-ray photoelectron spectroscopy (XPS), near-edge X-ray adsorption fine structure spectroscopy (NEXAFS) and density-functional theory (DFT) calculations, the thermal stability and orientational ordering of PPA-SAMs on the polar and mixed-terminated ZnO surfaces were analyzed. On all surfaces, PPA-SAMs remain stable up to 550 K, while at higher temperatures a C-P bond cleavage and dissociative desorption takes place yielding two distinct desorption peaks. Based on DFT calculations, these desorption channels are attributed to protonated and deprotonated chemisorbed PPA molecules, which can be related to tri- and bidentate species, hence allowing to determine their relative abundance from the intensity ratio. Beside immersion, an alternative monolayer preparation based on vacuum deposition in combination with controlled desorption of excess multilayers is demonstrated. This enables a SAM preparation on bare ZnO surfaces without any precoating due to exposure to ambient air, which is further compared with SAM formation on intentionally hydroxylated substrates. Corresponding TDS data indicate that initial hydroxylation favors the formation of tridentate and deprotonated bidentate, while the OMBD preparation on bare surfaces yields a larger fraction of protonated bidentate species. The orientation of PPA molecules adopted in the SAMs was determined from the dichroism of K-edge NEXAFS measurements and reveals an almost upright orientation for the deprotonated species, while a slight tilting is obtained for monolayer films with a large fraction of protonated bidentate molecules.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.