Abstract
Abstract Rim wheel testing through the SAE standard is necessary for driving safety. This study focused on rim wheel tests carried out using the dynamic radial fatigue test method, which has been included in the SAE standard using Fusion360 for the design and ANSYS for the simulation. With different parameters for the rim wheel type, only some parameters of the tested rim wheels were able to pass the standardization by SAE; 16 rim wheels passed the test, while the other 11 rim wheels did not pass. Simulation results suggested that variations in the thickness, geometry, and material affected the displacement of the safety factor, which was inversely proportional. In addition, the variation in the rim wheel produced a change in the safety factor due to changes in its mass and cost, which were directly proportional. The results of this study will aid in rim wheel design, not only in terms of achieving the best performance but also with regard to cost efficiency.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
