Forced Vibration Induced by Dynamic Response Under Different Inlet Distortion Intensities

Abstract

Boundary layer ingestion propulsion systems have attracted much attention due to their significant potential to reduce the fuel consumption of future commercial aircraft. However, the aeroelastic stability of the fan blade is affected by the continuous non-uniform incoming flow induced by the ingestion of the boundary layer. When the fan blades rotate in the junction area between the distorted area and the clean area, blade pressure fluctuations occur. This phenomenon triggers a dynamic response process in the blade. Previous numerical investigations explored the influence of the distorted inflow on the blade vibration amplitude, and found that there are two sources of low-order excitation to the blades: the distorted inflow and the dynamic response of the blade. The results show that the low-order excitation existing in the distorted inflow varies sinusoidally with the distortion extent. However, as a new source of excitation, the key influence mechanism of dynamic response is still unclear. To explore this issue, calculations and analyses were conducted for different distorted inflow intensities. The results show that the blade vibration amplitude increases with the rise in distortion intensity. The total pressure at the leading and trailing edge of the rotor blade was extracted for analysis. It was found that when the blade enters or leaves the distorted area, there is a consistent lag in the change in total pressure at the trailing edge compared to the leading edge. This lag leads to an abrupt variation in the total pressure ratio, which constitutes the dynamic response process of the rotor blade. This periodic change generates a second-order excitation that causes the blade to vibrate.