Force-to-failure of a simulated implant-supported complete fixed dental prosthesis reinforced with glass fiber

Abstract

Statement of problemThe joint adjacent to the cantilevered section of an implant-supported complete fixed dental prosthesis (ICFDP) undergoes the most stress because of force magnification in this area, making it more prone to mechanical failure. PurposeThe purpose of this in vitro study was to evaluate the ultimate force-to-failure distal to the terminal implant of a simulated ICFDP reinforced with glass fiber compared with that of a conventionally fabricated prosthesis. Material and methodsThirty ICFDPs with bilateral distal cantilevers were fabricated and divided into 3 groups: the not-reinforced (NR) group was processed without reinforcement, the glass-fiber-reinforced (GR) group was reinforced with glass fiber, and the titanium-reinforced (TR) group was fabricated with a titanium bar. The specimens were screw-retained onto a standardized mandibular model with 4-implant analogs embedded in acrylic resin. All groups were processed using heat-polymerized acrylic resin. After 24 hours, the cantilevers were loaded to fracture (in N) 10 mm away from the center of the most distal analog under compression at a crosshead speed of 1 mm/min. Statistical analysis of data was performed using a 1-way analysis of variance (ANOVA) model by using Tukey B post hoc comparison procedures (α=.05). ResultsData revealed the mean fracture load of the NR group was 1073 ±108 N, 1400.75 ±123.53 N for the GR group, and 1652.78 ±274.14 N for the TR group. Statistically significant differences (P<.05) were found among all 3 groups. Comparison between the left and right side of the tested prostheses did not show any significant differences (P=.595). ConclusionsA fiber-reinforced ICFDP provides better biomechanical properties than an unreinforced one, which may allow its longer-term use as an interim ICFDP. However, the titanium bar ICFDP still provided the best resistance to fracture.