Abstract
The theory and implementation of a flux-linkage controller applied to a switched reluctance machine drive are described. Analysis of the simplified discrete time load model shows that a simple flux-linkage controller can produce a ‘dead-beat’ system response. Comparison of the response from a discrete time PID current controller, hysteresis current controller and the new flux-linkage controller, show that the flux controller has a much improved response. The experimental controller is used to control an IGBT converter, driving a commercial 7.5 kW switched reluctance motor. A method of constant torque operation is introduced. This takes account of limitations imposed by the finite DC-link voltage and rotor speed when calculating the reference values. The method is based on ‘flux ramps’, where the ramps are chosen to give constant shaft torque, and remain within the capabilities of the power converter. Correct selection of the flux ramps allows constant torque operation to be achieved over a wide speed and torque range. Measured results for the experimental drive demonstrate the low torque ripple achieved for motoring and generating operation over a range of speed and torque values.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
